HY-9055 of Electronic Potting Silicone Rubber
1. Product Feature of Electronic Potting Silicone Rubber
Electronic Potting Silicone Rubber is a kind of low viscosity, Inherent flame resistance, two components addition cured potting silicone with heat-conducting. It cures with both on room temperature and heated temperature. It has the feature of the higher temperature the faster of the curing time. It can be applied to electronic components for insulation, waterproofing, fixed and flame retardant. It mainly applied in electronic components surface with materials of PC(Poly-carbonate)、PP、ABS、PVC, etc. and
2. Typical Application of Electronic Potting Silicone Rubber
HY-9055 electronic potting silicone rubber could be applied to
- high powered electronics,
- DC/DC module and circuit board which requires heat dissipation and high temperature resistance.
-It can be broadly used for LED screen, Wind Power Generator, PCB substrate, etc.
Technical Parameters of of Electronic Potting Silicone Rubber
Features |
Part A |
Part B |
|
Before Curing |
Appearence |
Gray Fluid |
White Fluid |
Viscosisty(25℃cps) |
2500±500 |
2500±500 |
|
Operation features |
Mixing Ratio |
1:1 |
|
Viscosisty(after mixing) (cps) |
2000~3000 |
||
Operating Time(25℃ hr) |
120 |
||
Curing time (min,25℃) |
480 |
||
Curing time(80℃ hr) |
20 |
||
After Curing |
Hardness(Shore A) |
55±5 |
|
Thermal conductivity [W(m·K)] |
≥0.8 |
||
Dielectric Strength(KV/mm) |
≥25 |
||
Permittivity(1.2MHz) |
3.0~3.3 |
||
Volume Resisivity(Ω·cm) |
≥1.0×1016 |
||
linear expansibility [m/(m·K)] |
≤2.2×10-4 |
||
Fire Resistance |
94-V1 |
(Pls note: the above data for this product in 25 ℃ temperature, 55 percent humidity conditions, for reference. The accurate data is measured by customers when using.)
PACKAGE
40Kg/pail as a set (Part A 20Kg + Part B 20Kg)
Shenzhen Hong Ye Jie Technology Co, Ltd.
Amanda
Mob/WhatsApp/Wechat :+86-18938867547
Skype:Amanda Yao
QQ:2355542553
Email: hyjwzq(at)szrl.net
Website: www.szrl.net
Facebook: +86-18938867547