Digital Multimeter

The meter is a handled, battery-operated tool for measuring electrical parameters. It has all the features of a digital millimeter and measure AC voltage, DC voltage, AC current, DC current, resistance, capacitance, frequency, duty cycle ratio, dBm, TC, RTD, Diode Test, and Continuity Check.
Besides, it has features like:
Large LCD screen could display the three characteristic of one input signals.
Different reference impedance for dB measure function.
AUTO HOLD, DISPLAY HOLD and PEAK HOLD to display the measuring value.
Panel calibration function.
Three convenient data recording modes: LOG mode, MANUAL mode, and COMP mode.
USB-IR jack to connect with a PC
Open-case Inspection
Open the case to check, if the meter is damaged or something is missing, contact the place of purchase immediately. Contact the distributor for information about DMM accessories.
Accessories: A copy of users manual
A set of CF-733370 industrial test lead
One USB to UART Bridge Controller (USB_DMM)
DMMVIEW_ A disk
Options: K-TYPE TC
Safety Information
The meter complies with IEC61010.1-93 Over voltage Pollution Degree 2. Use the meter only as specified in this manual. Otherwise, the protection provided by the meter may be impaired.
A Warning identifies conditions and actions that pose hazards to the user.
A Caution identifies conditions and actions that may damage the meter or the equipment under test.
A Notice identifies symbols of the operation and explanations of the features. International symbols used on the meter and in this manual are explained in Table 1-1.