Agro-Biomass Pelleting Mill 1. All damaged spare parts of agro-biomass pelleting mill can be repaired or replaced in one year within one year after it's sold and delivered, except failures caused by users themselves or normally scrapped wearing parts. 2. Some parts in the agro-biomass pelleting mill bear great loads and are very easy to wear. Therefore we recommend users to prepare some necessary wearing parts in storehouse. Our company will provide whatever users need in time. 3. Users should obey the rules in this manual strictly during the process of installation, using, operation and management. If you have any questions about it, send staff to our company for free training and we will make no stranger to them. If users ask us go to your place for instruction and training, we can send our technicians there but we will charge for some traveling and training expenses. 4. Pellet plant is one of the most important devices for feed factory, so please keep, use and repair it carefully. After several years of use, wood pelleting mill must be repaired greatly. If users are not able to repair it, our company can serve for you. There are two cases: A). Carry the machine back to us. We will repair or replace some spare part according to actual condition, and make it reach the original capacity after assembly, adjustment and spray paint of the surface. B). List the spare parts which have to be repaired or replaced and we will manufacture them for you. Users can assemble and adjust them on your own, or invite our technician to go there for instruction under your cooperation. And you can also invite our ship-fitter to go to your place for assembly and adjustment until trial run and discharge feed. The relative expenses should be paid by users. Add to Basket