This Shot Blasting Machine is designed for the large, middle and small calibre size of the steel tube and the cylinder. Large steel tube shot blasting machine 1. Usage QG Series Steel pipe Shot dedicated processor inside and outside the wall for the steel and steel products to deal with the outer surface of the shot blasting to remove the oxide layer and debris such as welding slag, showing a metallic luster, to increase their surface area in order to facilitate the work painting and painting. Characteristics: Blast wheel arranged in a suitable location (such as room or the side of body below), the workpiece edge to edge into the rotation, will enable the different effect of diameter of the pipe line Shot 2. Introduction Protecting plate The cabinet of main impacting district has the high wear-resistant steel manganese 13. This protecting plate is our new research, installing more simply and repairing more conveniently. Sealed steel import and export Given the specific characteristics of the workpiece cleaning, shot blasting machine designed for quick exchange of the door of the chamber body. When the clean-up of large-diameter workpiece, the replaced door Sandy; When cleaning small diameter of the workpiece when the door to put on small-bore. This could very well seal. Workpiece drive mechanism Shot blasting machine of this type can be assigned a variety of workpiece drive mechanism, Such as Tire, V-Ramp Roller and so on. Blast wheel This machine's blast wheel installed in the suitable location of the cleaning cabinet(Side or Top). It can be very good clean-up different diameter of the workpiece. Shot recycling & purifying system This system can be divided into the Abrasive recycling system and purify System, they consist of abrasive hopper, Abrasive conduit, shot valves (Blast wheel Assemblies), screw conveyors, bucket Elevator, abrasive /dust and separator, etc. Dust-removing system This system consists of collector, fan and connecting pipes(from the clean-up room, separator to the collector) and so on. Connecting pipe equipped with butterfly valves for regulating the air volume, so that the work of the various parts of equipment to achieve the best state, so that no dust in the course of their work spillove 3. Technical parameters of QGW30 of equipment: Size of cleaning pieces: 50--300mm Abrasive flow rate: 2*250kg/min Lilting amount of elevating conveyor: 30000 kg/min Separating amount of separator: 30000kg/min Ventilation capacity: 6000m³ /h Power 50kw
