Laser Cutting / Engraving Machine (TY-1280P) The aim of the R&D of this series laser cutting machine is to put the moving control into full play and therefore increase the working effects of laser processing. In each aspect, from the software design, mechanical structure to the configuration, the tenet is to serve for the processing to make sure the stability, precision and speed under the safe and overall quality-management working environment. There are two working places for this laser cutting machine/engraving machine, which can alternate automatically so that the machine can cut while feeding and the feeding time is greatly decreased. Adopting high quality stepping motor imported from Germany High speed USB2.0 port saves the computer resource Memory card can save 128 files Imported linear guide adopted to ensure the stable feeding Manual switch easier to operate Laser power: 30-100W(Optional) Cutting speed: 0~20m/min(plexiglass, others determined by materials) Processing area: 1200mmX600mm Moving platform: 2800mm(left to right1400mm) Resolution ratio: ≤ 4000dpi Power supply: AC220V&plus-minus; 10%, 50Hz Location precision: &plus-minus; 0.1mm Number of hanged line: 60line Gross Power: < 1250W Operating temperature: 0° C-40° C Operating humidity: 5-95%(Free of condensed water) Graphic format supported: BMP, GIF, JPGE, PCX, TGA, TIFF, PLT, CDR, DMG, DXF. Two working places can alternate vertically and enable the cutting while feeding 100% production increase, 10% material consumption decrease and no abrasion on the baseboard Continuous circle cutting and the maxi circle cutting speed: 30m/min Laser power and speed can be matched automatically to ensure the best effects USB2.0 high-speed port Insulation system and high speed difference input and output electro circuit design can avoid the aberrance in distant signal transportation and realize the 12 working status output and 16 status input, which can easily connect with the working processing. 128 files can be save for the off-line computer work, which is proper for large quantity and repeat processing. Save the labour: One worker can operate more than 10 sets after training.
