MICROMAT™-F / MINIMAT™-F
The intelligent Hand-Screwdriver.
With Multi-Function Control to guarantee a quality control of your product.
According to application: straight handle, pistol grip or angle head design
shut-off when torque is reached
Counts screwdriving cycles
Supervises assembly times
Recognizes change of parts
Supervises its own operation
With activation of the driver, the airflow is released through the newly designed and improved controller fc10 in connection with the pneumatic controller pc10. When the preset torque is reached, the driver shuts off using the gigh accurate shut-off clutch of the screwdriver series MINIMAT-ULTRA. The integrated function-recognition reports the completion of the screwdriving cycle to the controller fc10.
The required assembly time is compared to a minimum and maximum allowable assembly time. If shut-off event ans assembly times range within the pre-determined window, an O.K. signal is given.
Zusätzlich kann die vorgegebene Anzahl der Schraubvorgänge je Werkstück kontrolliert werden.
Consequently is guaranteed, that the assembly was correctly completed and was not completed prematurely, because of hardware problems with product or screw to be assembled, premature release of driver from the screw location, trying to drive an already assembled screw a second time, or because screw thread is stripped.
Additionally, the programmed amount of screw assemblies per product can be controlled.
A proximity switch recognizes the product change.
In short, the Screwdriver with Multi-Function Controller monitors itself and assures a 100% correctness of your assembly.
The MINIMAT-F Screwdriver incorporates the well-known advantages of the - MINIMAT-ULTRA Screwdriver and oilfree operation is possible.
When connected to an automatic Screwfeeder, the feeding of the screw is controlled by the fc10. Here, the function of the feeder flow-sensor is supported by flow-sensor of the controller pc10. The controller is connected to the Screwfeeder using an optionally available SZG-connection set.