Product Name: Desiccant Air Dryer, Adsorption Air Dryer, Regenerative Air Dryer, heatless Air Dryer, Compressed Air Dryer Heatless desiccant air dryers use desiccant media to adsorb moisture and contaminants from compressed air. The desiccant media can be regenerated, or purged of the moisture it collects, and used again and again. Our desiccant air dryers use this process to allow compressed air to be dried to very low dew points of either -40° C, -70° C, or -90° C. These low dew points are necessary for critical compressed air applications or for those in extremely cold ambient conditions where any moisture remaining in the air would freeze inside compressed air system piping and block flow. The twin-tower design of our dryers allows simultaneous compressed air drying and desiccant regeneration - without interruption to compressed air flow. We manufacture air dryers with heatless or heated regeneration to meet the broadest range of application and operator requirements. Features: Energy Savings Options Low Profile Design High Performance Valves Convenient Service Access Advanced Controls Remote Communications Ready Optional Configuration: 1 Molecular sieve or activated alumina + molecular sieve dual bed 2 Dew Point switch mode 3 High Dew Point alarm 4 heating temperature dual lock 5 front/back filter pre-installed 6 PLC/LCD monitor and communication port Technical Data: Flow capacity: 0.7-510m3/min Working pressure: 4 to 10 bar Air inlet temperature: ≤ 45º C Air loss ≤ 14.5% Pressure drop ≤ 0.021MPa Pressure dew point: - 40º C to -70º C Switch cycle: 5 to 10 miniutes(adjustable) Desiccant; Activated alumina Voltages: 220V/50Hz
