Product details: Features: Use ordinary USB pen driver as the medium for transfer design. Same size, same interface with floppy driver, easy to install. Connect through floppy driver interface, no need to modify system settings. 1.44MB/720Kb built-in flash memory, used for conversion of file system between USB pen driver and format of floppy disk. Put files needed now only under root directory. (only files under root can be selected). Function: Two button used as IN and OUT instruction. Press the IN button to transfer files from USB pen driver to built-in memory, When the total capacity of files in current directory exceed 1.44MB/720Kb, press IN button again to transfer files into built-in memory, and the OUT button is used to transfer files from machine to USB pen driver. Operation: Read sequence: 1. Plug USB pen driver. 2. Red lamp on, 1-20 seconds later, it off. 3. Operate machine to read disk. 4. If total capacity of files in current directory exceed 1.44MB, and file you need is not in current space, press IN, goto step 2. Write sequence: 1. Plug USB pen driver 2. Red lamp on, 1-20 seconds later, it off. 3. Press OUT, red lamp on. 4. Operate machine to write disk. 5. After the machine display it finished, wait the green lamp off. 3 seconds later. 6. Press OUT again, 1-20 seconds later, red lamp off. Description: The built-in memory will refresh after the next read operation, no need to manage the file in built-in memory. The built-in memory will clear after the step 3 of write sequence, so when do the write operation, make sure the file name you write to disk is different with the file exist in USB pen driver, otherwise, the file in USB pen driver will be covered by the new file from machine after the write operation. Note: Some model of machine: TMFD TME-DC etc only support the 2DD floppy disk(720Kb capacity), then only the model FUSB-TL can be used. Some of TFKN TFGN etc use a floppy driver model: YD-702D-6238, set the jumper as JP-A, if the model: YD-702D-6639 etc, set the jumper as JP-D. For Chinese machine, we have a small printing circuit board for the front panel, if needed, you can install it. For BARUDAN BEMS BEMX, confirm if it support designs with both BARUDAN FDR format and TAJIMA format(. Dst. Dsb), if not, the conversion unit can not be used on it. The FUSB-TL only support TAJIMA format. If BARUDAN BEMS support TAJIMA format, store the design as file name start with 3 numbers, (for example 023***. Dst 004. Dst etc).
