ISO6508 M-1 Hardness Tester 0.5HR Resolution for Metals, Iron, Steel, Copper, Aluminium Tests the superficial hardness of metals. The test principle and accuracy comply to standard ISO6508. With the bench stand it can be used on the desk as well as on site. Tests the hardness of thin plate, slim pipe, thin shaft, small ball and small stampings, workpieces with small supporting surface as well as parts requiring small indentation, replacing Vickers hardness tester. It is used for finished workpiece NDT test directly.The small indentation is non-destructive to most workpieces. Traceable standard hardness block. Indenter inspected with standard Rockwell hardness tester. Test force calibrated with load cells directly traceable to national secondary benchmark. Copyright ?2008 TX Testing Instruments Co., Ltd. All Rights Reserved. Web Design by Hengjishangwu Chinese | Add to IE Favourites Details: Initial Test Force: 3kg Total Test Force: 15kg, 30kg, 45kg Force Applying Method: By screw Indenter: 120iamond cone 1.588mm carbide ball Accuracy: Meets the requirements of ISO6508 Resolution: 0.5HR Testing Range: HRN, HRT, HRW, HRX, HRY, etc. 15 scales. Application: All metals including iron, steel copper, aluminium, zinc, lead, tin, carburized steel, nitrided steel etc. M-1S: For Superficial testing case-hardened stocds up to 1"thick, thin stock and soft materials in Rockwell N and T scales. M-1ST: For Superficial testing small diameter tubing with walls. Anvil fits into 3/6"I.D.and larger. Rockwell 15-T scale only. M-2: 0-2"capacity. Weight:2.5 lb/1.23kg M-2S: (Superficial)0-2" capacity for Rockwell N and T scales