When we set up a AAC block factory to produce blocks, will use AAC mould for the blocks molding, then the block with be cutted by AAC cutting machine, when they reached the standard strength. Description of mold In the third stage of AAC block machine production line, we need use mold/mould and side plate, for the AAC block casting and maintenance. Materials slurry can be put into the combining of the mould and the bottom surface plate. After Settiling, curing and foaming it can be solidified into the blank. The bottom surface plate can bear The blank which shall be cut by the cutting machinery. And fed into the autoclave to be hardened Gogether with the autoclaved car/steaming larry. The autoclaved car is a carrier to carry the bottom surface plates and the blank to enter and leave The autoclave. Purposes of Mold Sizes: 4.2m/4.8/6m Type: Movable and integral. Double-layer hollow side plates work for heat insulation, and the inner to enhance the rigidity, prevent from deformation and prolong the service life.
