High Pressure Casting

1) Production, High Pressure Casting 2) Material, Aluminum alloy A380 3) Surface finish, Shot 4) Machining, Drilling Tapping 5) Casting Equipment, 1250T Aluminum Die Casting Machine 6) Quality system, TS16949 available 7) Product Dimensions, 600mm*320mm*70mm 8) Product Thickness, Min 1.3mm Max 3mm This product is used for the production of lighting. Its main point of the requirement is the control of the density. The control will lay the foundation for the following surface finishing (Shot). There is no blister on the surface of the product, then we can meet the requirement of you required. As follow above requirements we choice the high pressure casting as the density of the product can be controlled effectively though the produce of the large-scale die-casting machine. As well known, only ensuring the density can guarantee the good state of mirror-polished. So we have the control procedures as follows, 1. First of all, it is the control of the raw material. We will take the spectral analysis and ensure the accuracy of the material. 2. We will conduct the first article inspection, inspection and the end pieces of test. We will conduct the devastating smash product, view if the density satisfactory. Then we will inspect the important of the product with the casting size and appearance and make the placement of products for the specific work surface to insure the surface is intact. 3. It is the same as the inspection procedures in the production of machining processes. We can use the test machine to control the dimensions. Lastly, I really believe that we can meet your requirements, as our professional and we are strict with the quality. If you are interested in any products of our factory, please send the detail drawing and samples of the products to us. We will offer you the most competitive price and perfect service.Ingredient List, Alloy Code Chemical Composition (%) Si Cu Mg Fe Mn Zn Ni Sn The Sum of Other Elements 7.5-9.5 3.0-4.0 ≤0.10 ≤1.3 ≤0.50 ≤3.0 ≤0.50 ≤0.35 ≤0.50