Man-made uncoiler-Roll forming machine-compture control system-hydraulic control system-form cutter 1. Leak frame load-bearing: 4T 2. Rack: Welding with 300H steel 3. The form of forming machine guiding filling: Side skip 4. The form of forming machine: Chain drive with wallboard type, the thickness of wallboard is 12mm. 5. Diameter of Shaft is: 72mm 6. Chain: 0.6 inch single row 7. Main motor power: 3kw double pole reduction box 8. Forming Speed: 8m/min 9. Number of tracks: 11 tracks 10. Roller material: High grade 45#steel 11. Hydraulic station power: 3kw 12. Hydraulic station oil pump: Gearpump 13. Cutting type: Hydraulic cut 14. Forming Cutting blade: Cr12 15. Heat treatment on cutting blade: HRC58° -60° 16. Thickness of coil sheet: 0.3-0.8mm 17. Coil width of material: 1000mm 18. Index error of length: ± 2mm 19. Controlling system: PLC 20. Voltage: 380V 3phase 60 Hz or at buyer's requirement Material of main equipment: Roller material: High grade NO. 45 forged steel, plated hard chrome on the surface of roller with thickness 0.05mm. Active shaft material: High grade NO. 45 carbon wrought steel at diameter 72mm. Cutting blade: Cr12 mould steel with quenched treatment. They are widely used as the roof of garden like factory, hotel, exhibition center, villa, civil construction, etc.
