SPECIFICATIONS:
Capacity-Pressing 1000 Tons
Bed Area (L-R x F-B) 48” x 48”
Top & Bottom Bolster Thickness6”
Daylight Between Bolsters 72”
Stroke 26”
Shut Height 46”
Main Ram diameter-Single Acting26”
Side Cylinders Dia. (2)- Commercial5” x 3”
Top Ejector Capacity 15 Tons
Top Ejector Stroke 6”
Bottom Ejector Capacity 15 Tons
Bottom Ejector Stroke 8”
Maximum Height Under Crane 24’
Tank Area 60” x 120”
Foot Print 4’ x 7’
PRESS OPERATING SPEEDS:
Advance600 in/min
Pressing w/Accumulator System (6” working stroke available)600 in/min (adj)
Return600 in/min
Top Ejector Extend 300 in/min
Bottom Ejector Extend300 in/min
HYDRAULIC PUMPING UNIT:
1-Axial Piston Pump
1-Double Vane Pump
1-Accumulator System
* 1-200 HP Electric Motor @ 1200 RPM, TEFC Double Shaft (Kaiser to furnish)
* Erie Press Systems requires certified print to design Pumping
unit S.A.P. –P.D.Q.
1-Full Voltage Motor Starter
Electrical Characteristics3/60/480
Press Operating Pressure4500 PSI
THEORETICAL TIME CYCLE:
Advance 14”1.4 Sec
Press 4”0.4 Sec
Return 18”1.8 Sec
Valve Response Time1.5 Sec
Acceleration & Deceleration1.5 Sec
TOTAL6.6 Sec
Theoretical Strokes Per Min6 Stk/Min
(Based on Accumulator Recovery)
CONDITION: Very Good-A well maintained press that was last used to forge aluminum parts. Currently partially disassembled and in storage.