Working area: 22' long x 48" wide x 12" high (6700mm x 1220mm x 305mm). Accuracy and repeatability +/- 0.004" (+/- 0.1mm) or better on all 3 axes. Full span table, 23' long (7010mm). Servo motors on all 3 axes. Minimum 1400 IPM (600mm/sec) rapid travel speed on all 3 axes. Servo Drives and Controller to interface with Mach2 PC based software. End of travel limit switches and mid travel calibration switches on all 3 axes (total 9 switches). Chain cable carriers for servo wiring, limit switches, spindle power, air, water. Allow room for additional cables/tubes e. G. Coolant. 4HP (3kW) Spindle, variable 1, 000 - 24, 000 rpm, water cooled, to suit automatic tool changer. Automatic Tool Changer, 16 Position. 6 x Workpiece Air Clamps. 2 x Flip Down End Stops. ATC to accept right angle drive tools for 90° Drilling/machining. Power: 220V AC, 50Hz, Single Phase. Machines crated and delivered to any places. 2 Year Warranty (bearings, shafts, ATC).
