When use normal alloy knife type line remover to remove cold solvent paint markings, road surfaces are often destroyed in different degrees, and also some markings are remained. If the hard waster which can not be easy to remove or clean away on the road surface especially the old road surface such as waste oil, mud, and the semi-loose sand are not completely cleaned before road-marking construction, the marking will quickly fall off along with the falling off the hard wasted after construction. Using traditional way to remove the hard waste, not only increase the cost of manpower, but also hard to ensure the effects. After construction, there will be some unnecessary compensation because of the bad quality of road-marking, and lead to loss. The TT-QC-II steel brush line remover has completely resolved the above problems. 1. Engine: America Briggs & Stratton 6.0HP vertical air-cooled gasoline engine. 2. Removal width: 100-450mm. 3. Removal strength control: Handle rotating type and the rotate speed of elimination grinding is controlled by throttle. 4. Removal grinding head: 12 bundles of close steel brush. 5. Removal method: First brush some special paint on the old road surface, after a few minutes, when the coating of old marking is soften, then start the machine to remove it. Remove the hard waste only need to start up remover directly. 6. Structure: High strength welded frame. 7. Running wheel: Special rubber wheel with abrasion resistance, which equipped with imported high-speed bearing. 8. Size & Weight: 875mm (L) × 505mm (W) × 1140mm (H). Weight: 110kg
