1. Engine: Imported Honda 20HP air-cooled electrical starting gasoline engine. 2. Driving system: Imported oil pressurized continuously variable speed transmission system (HTS) with automatic brake device that can freely go ahead, back off and stop. The left and right back wheels are equipped with a differential speed gearing to ensure it to drive freely around the curve and change directions timely. The hand brake system makes the driving more secure. 3. Driving speed: 0-22km/m. 4. Maximum climbing capacity: 15° . 5. Micro-electronic control system: This system sets four marking modes (also can make personalized design according to the customer's standard). Spray gun controller can freely change the guns between the single and double spray guns. 6. Chassis: A firm welded frame; Its surface has been chrome-plated or sprayed with corrosion resistance coating; Equipped with imported high speed bearing which ensures the whole machine lighter and more convenient. 7. Rubber wheel: The left, right, front and back wheels are gas-filled pressure resistance vacuum ones whose diameters are 400mm. 8. Guide rod: Can be freely adjusted to up, down, left and right. 9. Lighting and warning function: Equipped with highlight lights which makes the night working convenient. The warning lights whose flicker frequency can be freely adjusted greatly improve the safety of the marking work. 10. Paint pump: Equipped with single (type I) 20L/min plunger type high pressure airless pumps with big flow and stable pressure. Maximum pressure is 20mpa (Working pressure 10-15mpa). 11. Paint tank: The capacity is 250kg with a filter device in it. 12. Spray gun: Equipped with three new-type pneumatic spray guns and one hand spray gun with an lengthening pipe for spraying special signs like arrows and letters. The hard side columnar reverse washed nozzle (30/20) makes the on-spot discharging easy and convenient. The non-arc nozzle can enable the marking line straight and exact. 13. Available paint: Apply to spray cold solvent, water-based and two-component road marking paint. 14. Spraying width: 100-450mm. 15. Glass beads dispenser: Equipped with single pressurized 60L glass beads bin with a window. Single glass beads spraying gun can be equipped on the left or right that can freely adjust its pressure, flow rate and spray width to ensure the spraying glass beads firmer, evener and more economical. 16. Glass beads bin: The glass beads bin with a window to check the quantity of glass beads timely; The capacity is 100kg. 17. Pre-marking working synchronous with the marking operation, greatly improving the construction efficiency. 18. Size & Weight: 2900mm (L)× 1600mm (W)× 2400mm (H). 682kg Option for special trailer chassis, convenient for transportation. Option for portable hand-push road marking machine to mark special lines, such as pedestrian crossing, parking line and lane line
