SYSC-F series full automatic solar laminator consist of 3 stages: A, B, C. Stage A is loading system, Stage B is the main machine, Stage C is unloading and cooling system. The machine combine the manual mode, semi-automatic mode, full automatic mode in a whole. The operate interface designing is humanized. The safety gard system is equiped with the machine. And the whole structure is regulated to facilitate the operation and promote work efficiency.Type Laminating area (mm) Weight (T) SYSC-F2218 1800 X2200 12 SYSC –F3422 3400×2200 16.5 SYSC- F3622 3600×2200 18.5 SYSC- F3624 3600×2400 19.5 Technical Parameter Power supply: 380V 3 phase 5wire Vacuum pump speed: 70L/S Operate mode: Automatic /Manual Ultimate vacuum: 20PA Laminating time: 20Min Pumping time: 5min (Adjustable) Heating mode: Heat by SD320 oil Temperature control mode: Siemens PLC PID Control, Maximum temperature: 200 Work time : 24 hours continueously Work temperature: Normal -180 temperature precise: ≤±0.8 Temperature uniformity: ±1.5,Multi-point temperature control Evenness of the worktable: Evenness ≤200μm/m2 Air discharge speed: Can adjust continuously within 0-50L/S Press of compressed air 0.4—0.8MPa Flow volume of compressed air 420—800L/min Work vacuum degree 50-20Pa Height of Laminating cavity 40mm Cylinder Stroke length 80mm Rubber board Nonhazardous high temperature resist rubber board