Plastic products Extrusion Line 1. Material can be extruded out directly after two grades of mixing, and it can also be extrueded by two steps after pelleting. 2. The line is of characteristics of energy and space saving. 3. The line is consisted of conical twin screws extruder, caccum calibration table, haul-offunit, and stacker, and also coorinated with different kindls of moulds to producePVCdoor and profileMODEL YF180 YF240 Vacuum degree (MPa) -0.08--0.09 -0.08--0.09 Center height of T type dies (mm) 320 320 Height from ground to die (mm) 890-1100 890-1100 Moving distance of vacuum calibration table (mm) 400 500 Hauling speed (m/min) 0.3-7.8 0.1-4 Hauling force (KN) 7.5 30 Effective hauling length (mm) 1.0 1.8 Width of rubber (mm) 180 240 Cutting linear velocity (m/s) 58.6 58.6 Max. Cutting section (mm) 180×65 240×65 Add to Basket