Plastic Blow Molding Machine Blowing Machine Product desc: Single station(Max. 10L Screw 70), Material: PE PP; Hydraulic Pattern, Other choices according to customers' requirements: Multiple Dies, Multiple Layers, Visible Line, Parison Controller The 2L-16L single-station automatic blow moulding machinery include three series of DHS-2L, DHS-5L, DHS-10L and DHS-16L. A wide variety of materials can be used for the machine, which are suitable for producing multi-type products in small batches. The clamping system is a high-precision single-station linear guide, extrusion system using a hard gear reducer and inverter imported from Japan. The die head system adopts central-incoming extrusion die made of special steel, imported hydraulic valve and seal parts with proportional control valve. The control system consists of PLC and Human-machine interface imported from Japan, an automatic temperature control module and imported electrical parts Setting: Clamping---------Single station+Hight-precision guide+large arm cylinder axle Extrusion system--Hard gear surface reducer+Japan inverter Die system--------Central-incoming extrusion die with special steel Hydraulic system--Japan hydraulic valve seal and proportional control Control system----Japan PLC+Imported HMI+PLC automaticSpecification DHS-2LII DHS-5LII DHS-12LII DHS-16LII Material PE, PP… PE, PP… PE, PP… PE, PP… Max.container capacity L 2 5 12 16 Number of die set 1,2,3,4 1,2,3,4 1,2,3,4 1,2,3,4 Machine Dimension m 2.5×1.6×2.4 2.9×1.85×2.65 4.2×2.95×3 4.8×3.2×3.1 Total weight ton 4 5 7 8 Accumulator head DHS-2LII DHS-5LII DHS-12LII DHS-16LII Number of die heating zone 3 3 3 4 Power of die heating KW 4.2 5.8 6-7 6-7 Max die-pin diameter mm 60 80 140 140 Center distance of twin-die mm 130 160 240 260 Center distance of tri-die mm 85 110 160 180 Center distance of four-die mm 65 85 120 130 Clamping Unit DHS-2LII DHS-5LII DHS-12LII DHS-16LII Clamping force KN 38 70 110 155 platen opening stroke mm 158-410 209-510 209-620 219-600 platen size mm 290×320 350×380 460×500 500×490 Max mould size mm 320×320 400×380 560×500 600×500 Mould thickness mm 160-240 210-300 220-380 210-380 Extruder Unit DHS-2LII DHS-5LII DHS-12LII DHS-16LII Screw diameter mm 50 60 70 75 Screw L/D ratio L/D 24:1 24:1 24:1 25:1 Extruding Volume Kg/hr 30-50 60-80 100-120 100-130 Number of heating zone zone 3 3 3 4 Extruder heating power KW 3-4.4 5-6.6 6-8.2 7.3-8.6 Extruder driving power KW 11-15 15-18.5 22-30 22-30